Rail King RAILKING F-3 AA SET Manuel de l'opérateur télécharger pdf (Page 15)

The marker lights for the tender can be replaced following the same procedure

use for the engine. Remove the six screws that attach the tender body to the

tender frame.

To replace the Tender Marker LEDs:

1. Unplug the yellow connector in the rear

of the tender shell. See fig. 8b

2. Gently pull on the wires from the

bottom of the marker housings and

through the rear of the tender shell.

3. Gently thread the new LEDs through the

rear of the tender shell and into the marker

light housing.

4. Reconnect the yellow connector.

Cab Interior Light:

1. Unplug the black connector at the rear

of the boiler shell. See fig. 8a

2. Gently pull on the wires to remove the light bulb from the backhead.

3. Gently push the new light bulb into the backhead.

4. Reconnect the black connector.

Firebox Glow Lights:

1. Unplug the black connector at the rear of the engine chassis. See fig 9.

2. Gently pull on the wires to remove the light bulbs from the bracket.

3. Gently push the new light bulb into the bracket.

4. Reconnect the black connector.

After replacing the light bulbs replace the boiler shell and the 6 screws. Be careful

not to pinch any wires when placing the boiler shell back on the chassis.

To access Tender Marker

LEDs

Firebox Lights

RailKing 4-6-6-4 Challenger

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 23 24

Pas de commentaire

Rail King RAILKING F-3 AA SET Manuel de l'opérateur Page 15