Rail King RAILKING F-3 AA SET Manuel de l'opérateur télécharger pdf (Page 14)

Headlight Replacement Instructions

A constant voltage circuit in the engine

controls the locomotive’s lights. They

are easy to remove and replace when

they burn out. To replace the light bulbs

in the engine remove the 6 screws that

attach the boiler as shown on page 11.

Then remove the boiler.

You can obtain replacement bulbs

directly from the M.T.H. Parts

Department (Order online: www.mth-

railking.com, e-mail: parts@mth-

railking.com,Fax: 410-423-0009, Phone:

410-381-2580, Mail: 7020 Columbia

Gateway Drive, Columbia MD 21046-

1532, ).

Headlight:

1. Remove the pilot assembly.

2. Remove the screw that attaches the

headlight shell.

3. Unplug the blue connector in the

front of the boiler shell.

4. Gently pull on the wires to remove

the light bulb from the headlight

shell.

5. Gently push the new light bulb into

the headlight housing.

6. Reconnect the blue connectors.

7. Reassemble pilot and headlight shell.

Marker LEDs: The marker lights are illuminated by Light Emitting Diodes

(LEDs). LEDs draw very little current and should last a long time when compared

to light bulbs. However, if one LEDs fails, both must be replaced as set, since they

are wired together. To replace the front LEDs:

1. Unplug the yellow connector in the front of the boiler shell.

2. Gently pull on the wires from the bottom of the marker housings and through

the sides of the smoke box.

3. Gently thread the new LEDs through the sides of the smoke box and into the

marker light housing.

4. Reconnect the yellow connectors.

RailKing 4-6-6-4 Challenger

To Access

Cab Lights

To Access Headlight

in Pilot Assembly

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 23 24

Commentaires sur ces manuels

Pas de commentaire

Rail King RAILKING F-3 AA SET Manuel de l'opérateur Page 14

Commentaires sur ces manuels

Produits connexes et manuels pour Jouets et accessoires Rail King RAILKING F-3 AA SET