Rail King RAILKING F-3 AA SET Instructions d'exploitation télécharger pdf (Page 5)

RailKing F-3 AA Set Operating Manual

order for Proto-Sound® to properly initiate the system check, do not

advance the transformer throttle past 10 volts when you first enter RESET,

wait for the diesel startup sounds to begin and then slowly turn the

transformer throttle to the off position and then back on again to enter the

forward phase. Interrupting the power too quickly may cause the system to

re-enter RESET (signaled by two dings of the bell). Should this happen,

wait longer before interrupting the power to enter the Forward phase.

Proto-Sound® comes with several programmable functions, including

Engine Volume Adjustment, Separate Bell Button Operation

(pre-programmed at the factory), Cab Chatter On/Off Control, and

Horn-In-Neutral Operation. Each of these features are described in more

detail later. You will notice that when in RESET, your engine will not

respond to the whistle button with a horn blast or continuous bell ringing.

In fact, when in RESET and the whistle button is depressed, only one single

bell chime will be heard each time the whistle button is pressed. If you

don’t want to configure or change your locomotive using any of these

programmable features, simply leave RESET and wait 5 seconds before

interrupting the power to put the engine in forward. After you leave

RESET, your engine will operate normally in all the direction states of

forward, neutral and reverse.

HORN OPERATION

Your RailKing F-3 AA Set Proto-Sound® equipped engine is equipped

with a digital recording of a diesel horn. The horn sound can be activated

anytime the engine is in forward or reverse by pressing the whistle button

on your transformer. The horn will continue to blow as long as the whistle

button is depressed. The horn will not function in RESET and must be

configured through a RESET option to allow the horn to work when the

engine is in neutral. See page 19 for information on horn programming in

the Using RESET To Program Proto-Sound® section of this manual.

BELL OPERATION

Your RailKing F-3 AA Set Proto-Sound® equipped engine is equipped

with a digital recording of an actual diesel bell. Unlike previous versions of

Proto-Sound®, the bell can be turned on or off with any separate bell

button, like the Lionel® Railsounds® No. 5906 Bell Button, by simply

pushing the button. If you don’t have a separate bell button, the bell can be

controlled through your transformer’s whistle button whenever the engine

1 2 3 4 5 6 7 8 9 10 ... 31 32

Pas de commentaire

Rail King RAILKING F-3 AA SET Instructions d'exploitation Page 5