Rail King 4-6-4 J3a Hudson Manuel de l'opérateur télécharger pdf (Page 8)

Activating Features Using AC Power

Using an AC output transformer equipped with a whistle and bell button will unlock

dozens of features inside your RailKing One-Gauge locomotive. Operation is simple by

following the simple steps below and on the following pages.

Start Up - Turn the throttle knob up ½-way, until the engine headlight shines bright.

Put the engine into motion by pressing the Direction button on your transformer once.

(hold it for approximately 1 second)

If the engine does not begin to move as soon as you firmly press the Direction button,

you may not have sent enough voltage to the track to make the train move. Turn the

throttle up a bit higher until the train begins to move.

Throttle - To increase or decrease track

voltage, and therefore train speed, turn the

throttle control knob. Turning clockwise

will increase voltage and speed, while

turning counterclockwise will decrease

voltage and speed. The engine will

maintain the speed you set after you release

the throttle until you turn it again to change

the voltage and speed.

Bell - To sound the bell, in an engine equipped with a bell firmly press and release the

Bell button. To turn the bell off, press and release the Bell button again. The bell will

continue to ring from the time you turn it on until you press and release the button again

to turn it off.

Horn/Whistle - To sound the whistle, firmly press the Horn/Whistle button. The whistle

will sound for as long as you continue to depress the button. It will stop when you

release the button.

Direction Your train is programmed to start in neutral. The train will always cycle

neutral-forward-neutral-reverse with each press and release of the direction button. The

engine is programmed to restart in neutral each time the track voltage is turned off for

25 seconds or more.

Automatic Grade Crossing Signal DCS Mode Only - Customers that operate this engine

in DCS will find a new feature added to the engine sound set. Now there is a soft key

(SXS) that sounds the correct 2 longs, a short and another long whistle blast to

announce that the train is approaching a grade crossing. To sound the grade crossing

signal, locate the soft keys at the top of the DCS Remote. Scroll to the left until SXS

acronym is showing. A single push and release of the SXS soft key will produce the

correct 2 longs, a short and another long whistle blast of the Grade Crossing Signal.

Anytime you want to sound the Grade crossing Signal just press and release the SXS

soft key.

4-6-4 J3a Hudson Steam Locomotive

Cycle Phases

Neutral

ForwardReverse

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 27 28

Commentaires sur ces manuels

Pas de commentaire

Rail King 4-6-4 J3a Hudson Manuel de l'opérateur Page 8

Commentaires sur ces manuels

Produits connexes et manuels pour Jouets et accessoires Rail King 4-6-4 J3a Hudson