Rail King 4-6-4 J3a Hudson Manuel de l'opérateur Page 8

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 30
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 7
8 4-6-4 J3a Hudson Steam Locomotive
Activating Features Using AC Power
Using an AC output transformer equipped with a whistle and bell button will unlock
dozens of features inside your RailKing One-Gauge locomotive. Operation is simple by
following the simple steps below and on the following pages.
Start Up - Turn the throttle knob up ½-way, until the engine headlight shines bright.
Put the engine into motion by pressing the Direction button on your transformer once.
(hold it for approximately 1 second)
If the engine does not begin to move as soon as you firmly press the Direction button,
you may not have sent enough voltage to the track to make the train move. Turn the
throttle up a bit higher until the train begins to move.
Throttle - To increase or decrease track
voltage, and therefore train speed, turn the
throttle control knob. Turning clockwise
will increase voltage and speed, while
turning counterclockwise will decrease
voltage and speed. The engine will
maintain the speed you set after you
release the throttle until you turn it again to
change the voltage and speed.
Bell - To sound the bell, in an engine
equipped with a bell firmly press and release the Bell button. To turn the bell off, press
and release the Bell button again. The bell will continue to ring from the time you turn it
on until you press and release the button again to turn it off.
Horn/Whistle - To sound the whistle, firmly press the Horn/Whistle button. The whistle
will sound for as long as you continue to depress the button. It will stop when you
release the button.
Direction Your train is programmed to start in neutral. The train will always cycle
neutral-forward-neutral-reverse with each press and release of the direction button. The
engine is programmed to restart in neutral each time the track voltage is turned off for 25
seconds or more.
Cycle Phases
Neutral
Neutral
ForwardReverse
Vue de la page 7
1 2 3 4 5 6 7 8 9 10 11 12 13 ... 29 30

Commentaires sur ces manuels

Pas de commentaire