4-6-4 J3a Hudson Steam Locomotive 3
Set Up Checklist
•
Install the tender coupler
•
Lubricate the locomotive
•
Prime the smoke unit
•
Check to see whether the batteries need to be charged for full sound effects
•
Apply power to run as described in the Basic Operating Section of this manual
Installing The Tender Coupler
This RailKing One-Gauge locomotive can be equipped with three different types of
G-Gauge couplers - an M.T.H. knuckle coupler, an M.T.H. hook & loop coupler or a
1/32nd Kadee coupler. For your convenience, the M.T.H. knuckle and the hook & loop
couplers have been included with your locomotive. The Kadee type must be the 1/32nd
size and can be purchased from a Kadee coupler retailer. Prior to installation, you will
need to install the Kadee coupler base included inside your locomotive’s packaging.
Both the standard knuckle and the hook and loop coupler designs attach to the tender
truck in the same manner as seen in Figures 1 and 2.
Knuckle Coupler
In Standard Factory Position “A”
Figure 1: Knuckle Coupler Position “A”
Hook & Loop Coupler
Figure 2
Commentaires sur ces manuels